The FDA has lost a product jurisdiction case in DC district court to Genus Medical Technologies LLC over its barium sulfate contrast agent. The judge in the case ruled that the agency violated the Administrative Procedures Act in ruling that the product is a drug, but the FDA will have another crack at the matter as the application for the product has been remanded to the FDA.
The U.S. Environmental Protection Agency (EPA) has posted an advanced notice of proposed rulemaking for control of ethylene oxide emissions (EtO), which would update a 2006 final rule that declared no additional controls for EtO were necessary. However, the agency’s latest proposed rule makes note of several technological advances that allow for greater control of EtO, a fact that could drive a greater regulatory requirement for containment and destruction of EtO emissions at medical device sterilization plants.
Vancouver, British Columbia-based Correvio Pharma Corp. is hoping that it will receive a positive response from the FDA’s Cardiovascular and Renal Drugs Advisory Committee, which meets tomorrow to consider the U.S. approvability of Brinavess (vernakalant hydrochloride, I.V.), its antiarrhythmic drug for the rapid conversion of adult patients with recent onset atrial fibrillation (AF).
ORLANDO, Fla. – In an effort to get sickle cell disease (SCD) researchers, drug developers, patients and regulators all on the same page, the American Society of Hematology (ASH) and the FDA have released new recommendations aimed at establishing uniform global standards for clinical trial endpoints to evaluate new therapies.
New York-based startup 3Dbio Therapeutics snagged a rare pediatric disease designation from the U.S. FDA for Aurinovo, its investigational combination product for reconstruction of the outer ear in patients with microtia. The product offers an alternative to established treatments, none of which enable patients to regain an auricle comprising living tissue other than rib grafts, which are associated with significant donor site morbidity.
PERTH, Australia – Industry was supportive of most of the changes proposed by Australia’s Therapeutic Goods Administration (TGA) for custom-made and 3D-printed devices. However, the comments also indicated that the current regulatory requirements for custom-made devices are not well understood. The agency stressed that increasing use of 3D printing for medical applications is raising questions about the adequacy of the current medical device regulatory framework to mitigate risks to patients.
RSS
